Piezoelectric Nanogenerator Based on Electrospun Cellulose Acetate/Nanocellulose Crystal Composite Membranes for Energy Harvesting Application

Nanogenerators, as the typical conversion of mechanical energy to electrical energy devices, have great potential in the application of providing sustainable energy sources for powering miniature devices. In this work, cellulose acetate/cellulose nanocrystal(CA/CNC) composite nanofiber membranes were prepared by electrospinning method and then utilized to manufacture a flexible pressure-driven nanogenerator. The addition of CNC not only increased the content of piezoelectric cellulose I crystallization but also strengthened the mechanical deformation of the nanofiber membranes, which could greatly enhance the piezoelectric performance of CA/CNC composite membranes. The CA/CNC composite nanofiber membrane with 20%(mass fraction) of CNC(CA/CNC-20%) showed optimal piezoelectric conversion performance with the output voltage of 1.2 V under the force of 5 N(frequency of 2 Hz). Furthermore, the output voltage of the CA/CNC-20% nanogenerator device exhibited a linear relationship with applied impact force, indicating the great potential in pressure sensors.     

吉林大学化学学院研究生课程思政的多维度构建与探索*

研究生课程思政的建设影响着研究生的培养质量,关乎着能否实现立德树人这一人才培养的根本任务。介绍了吉林大学化学学院立足学科特点,在研究生课程思政建设方面取得成功的经验,并对未来的课程思政建设方向进行了探讨。     

Chelating Metal Ions in a Metal-Organic Framework for Constructing a Biomimetic Catalyst Through Post-modification

Crystal engineering, as a burgeoning technology, has been widely used to construct metalloporphyrins biomimetic catalysts. Herein, a bimetallic metal-organic framework (MOF) was constructed by 4-(4-carboxyphenyl)-1,2,4-triazole ligand, Co²⁺ and Zr⁴⁺ metal ions by solvothermal reaction(named PFC-88). A N,N-chelation site was found between the two adjacent ligands in PFC-88, consequently a porphyrin-like structure was obtained through chelating Fe³⁺ in this site by post-modification, named PFC-88-Fe. The result of a single crystal X-ray technology verified that Fe ions were successfully metalated in the N,N-chelation site of PFC-88, which is assisted by the X-ray absorption near-edge structure(XANES) spectra. An o-phenylenediamine oxidation reaction was applied to assessing the catalytic activity of PFC-88-Fe, in which the absorbance increases of phenazine-2,3-diamine at λ=418 nm were recorded by absorption spectroscopy in kinetic mode, exhibiting the application potential as a biomimetic catalyst.     

一种通过梯形PPMgLN波导倍频实现带宽可调谐光源的理论研究

本文设计了一种梯形的周期极化掺镁铌酸锂(PPMgLN)波导,并通过在传播方向上引入温度梯度来拓宽其倍频(SHG)过程的泵浦光源可接收带宽。通过有限差分的光束传输法,计算波导的有效折射率,并进行波导尺寸的设计。结果表明,通过改变梯形波导不同位置的温度,使其形成一个温度梯度,可拓宽泵浦光源的波长可接收带宽。本文所设计的PPMgLN波导最大泵浦光源可接收带宽为C波段,即1 530~1 565 nm,该波导可倍频C波段,得到输出波段带宽为765~782.5 nm,温度调谐范围为30~150 ℃。     

湿法消解-原子荧光法测定全血中硒

以全血样品为原料,探讨湿法消解-原子荧光法测定全血中的硒含量。血样经硝酸-高氯酸消解后,用硼氢化钠将硒还原成硒化氢,由氩气载入原子化器,产生的原子荧光强度与试液中硒元素含量在一定范围内呈正比,外标法定量。以消解效率为指标,优化样品的消解条件,测定血中硒在0-10μg/L范围内线性情况良好,相关系数为0.9992,最低检出限为0.143μg/L,相对标准偏差为1.51%-1.58%,平均加标回收率为90.86%-104.62%。血中硒的原子荧光测定法灵敏度高,精密度和稳定性好,可应用于血中硒的生物监测。     

氮分子A3Σu+、B3Пg、C3Пu电子态的高温高振转光谱研究

采用态平均（CASSCF）/高度相关多参考组（MRCI）方法，对N2分子A3Σu+、B3Пg、C3Пu电子态的势能、跃迁偶极矩进行了高度相关的精确计算．计算的势能在平衡位置附近与RKR拟合的势能曲线非常一致，获得的跃迁偶极矩与已有实验值符合很好。首次对A3Σu+、B3Пg、C3Пu电子态的振转光谱常数随振动量子数v的变化进行系统定量计算，其结果与已有的实验观测数据相符．同时，获得了N2分子第一正带系的0-1、0-2、1-0、1-2、1-3、2-0、2-1、2-3、3-0、3-1和3-2光谱带分别在300，3000，6000，10000K时的谱线强度，如1-0带在3000，6000，10000K时的高温谱线带强度分别为1.58543×10-16 cm-1/(分子 cm-2)、6.07889×10-17 cm-1/(分子 cm-2)和2.3781×10-17 cm-1/(分子 cm-2)．这些结果对N2分子进一步的理论研究、实际应用和高温大气的建模与研究具都有一定的参考价值．     

Hudson模型适用性及储层微观建模应用*

为明确裂缝间相互作用对各向异性的影响，本文以Hudson模型为例分析了裂缝密度、裂缝倾角对地震波波场、弹性常数和Thomsen系数的影响规律，然后采用“基质-骨架-流体”组合化的方法进行了裂缝储层微观尺度的建模，并与实际测井资料进行了对比。结果表明该模型适用条件为低裂缝密度储层，二阶模型适用的裂缝密度范围比一阶模型大，但在裂缝密度过大时，二阶模型会出现不收敛的现象，模型便不再适用。裂缝储层纵横波速度随裂缝倾角增大而增大，纵波速度对裂缝倾角更为敏感。另外，在与实际测井曲线对比时，在高裂缝密度地层二阶模型的应用效果明显优于一阶模型，说明了在高裂缝密度储层考虑裂缝间的相互作用的必要性。     

硅和锗纳米线的原子排布和电荷分布的密度泛函紧束缚方法研究

低维硅锗材料是制备纳米电子器件的重要候选材料，是研发高效率、低能耗和超高速新一代纳米电子器件的基础材料之一，有着潜在的应用价值。采用密度泛函紧束缚方法分别对厚度相同、宽度在0.272 nm~0.554 nm之间的硅纳米线和宽度在0.283 nm~0.567 nm之间的锗纳米线的原子排布和电荷分布进行了计算研究。硅、锗纳米线宽度的改变使原子排布，纳米线的原子间键长和键角发生明显改变。纳米线表层结构的改变对各层内的电荷分布产生重要影响。纳米线中各原子的电荷转移量与该原子在表层内的位置相关。纳米线的尺寸和表层内原子排列结构对体系的稳定性产生重要影响。